Announcement

Collapse
No announcement yet.

Motor shows up as Bumper

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Motor shows up as Bumper

    I have a 'Smart' motor that all of the sudden self-identifies as a bumper sensor in both the Device Menu and in the VEXos Utility. Is there any way I can update/reload the firmware so it shows up as a motor again?

  • #2
    Try unplugging everything from the brain, then plug the bad motor into port 1, then re-run VexOs utility and run an update on port 1

    Comment


    • #3
      You can also right click the device and force an update if it is being a bugger...

      Comment


      • #4
        I have a motor that was not registering at all when I plugged it in (showed empty port), and now it is recognizing it as a bumper switch occasionally. When I click detect device port 1, it flashed as a yellow outlined motor, then nothing. Do I click "force update" on the brain, or it that motor just dead?

        Comment

        Working...
        X